Tresrey Carbon Parts for the DEX210 Coming soon!

Tresrey Japan just released these photo's of the option carbon fiber parts for the DEX210. Timeline is yet to be confirmed but look for them stateside soon and we'll get them on the website ASAP.

Team Durango DESC410 Rear Bumper in stock!

Just got these in stock ready to go! These will be up on the website ready for purchase starting tomorrow!

New DEX210 Optional Parts!

Coming in stock soon! I'll have and ETA from Japan after the Holidays!

Tresrey Big Bores arriving 12/31!

Tresrey Japan has shipped out our Big Bores and they will be state side here the end of the month! Super Smooth make these a great upgrade to any Durango! Look for them on the website for pre-order tomorrow!

Tresrey Center driveshaft sets in stock!

We were running low here in the US but Japan just got a good re-stock back in and will be shipping out next week. We still have these in stock so don't hesitate to place your order. These are a great way to lighten up your drivetrain in your DEX410 or DEX410V3 (even though here is 2mm difference they will work just fine).

Installation Tips: Shrink wrap your CVD's, check your drive pins often, and keep your joint bushing lubed with bearing oil. These will help the driveshafts last longer and not "wallow" out the pin hole.

Team Durango DESC Rear Bumper coming Soon!

The DESC410R rear bumper has been realeased and should be in stock shortly.  The new full-width rear bumper gives extra protection as well as scale looks, and also meets the strict rules governing some race meetings where large rear bumpers are a requirement. The bumper can be run in lightweight or full-protection setups by adding or removing the included optional lower bar. The bumper comes supplied with instructions on fitting and you can read a full online guide on installing the bumper and cutting the bodyshell on the Durango website

Team Durango DEX210's in stock!

Just arrived today at the warehouse! Place your order before Christmas and we will include a Tresrey Carbon Fiber Steering brace as well!

Tresrey High Grade Bearing Kit DEX210

The HIGH GRADE BALL BEARING SET for Team Durango DEX210 includes 8pcs of 5x10x4mm and

4pcs of 10x15x4mm both plastic Teflon shield bearings for lower rotational resistance. Also includes

2pcs of 5x13x4mm Rubber shield ball bearings for outside (wheel side) of the rear hub carrier, and

two types of Metal shield ball bearings for the gear box and the differential for increasing drive efficiency and durability.

Buy them Now!

Tresrey V3.0 motors in stock!

Just got a fresh batch of V3's in stock! Check out the website for all the specs for the 6.5,7.5, and 8.5 motors

Tresrey Ceramic Diff Balls DEX210

These 3.0mm Ceramic balls have incredible circularity and surface strength for a super smooth Ball differential. This package contains 14pcs for Team Durango's DEX210 but it can be used for other cars which have 3.0mm sized ball differential. These are up on the website ready for order!

Tresrey Pics from Spektrum

A few pictures from the past Spektrum race. Both Cush and Justin did well and I'm sure are ready to go back next year and get some better results. Great job guys!

Team Durango DEX410R NOW IN STOCK!

Just arrived today! Check out the website to place your order! CLICK RIGHT HERE!

Team Durango DEX210 Diff Build guide

The diffs on the DEX210 are tricky to setup and assemble. Team Durango have released a great "how to" video so you can do it right the first time.

Tresrey Spektrum 2011 Results

Both Justin Salerno and Will "Cush" Cushing made their way to Spektrum and came out with some great results. Although both would have liked to have done better they did a great job to get their Tresrey cars up front.

Justin ran 175 buggy and Modified 4wd. After quals Justin managed to et in the 17.5 A-main and 4wd mod B-main. After it was all said and done Justin finished in 6th for 17.5 buggy and in 4th for the B-main 4wd mod.

Will "Cush" was running 2wd mod, 4wd mod and 4x4 SCT. Will put in some great laps during qualifying and finished well at Spektrum. 5th in 4wd mod B-main (Ironically right behind teammate Justin), while finishing well in 2wd mod and 4x4 SCT. With a little more time Will should be at the front soon!

Great job on both Justin and Will's part!

Team Durango DEX410R V3 Released!

Check it out!

Team Durango DEX410R V3

We have them on order and will have them on the website soon for pre-order!

Tresrey at Spektrum

Team Driver Justin Salerno was nice enough to send some picture of the track layout and his DEX410/DEX210 that he will be running this weekend. Also Will "Cush" Cushing will be running his Tresrey Durango's as well. If you have any questions on Tresrey products be sure to stop by and ask, either one will be more than happy to show you just how Tresrey products can improve your Durango platform.

GOOD LUCK GUYS!

Tresrey Round 7 2wd Race Footage

JConcepts Finisher Body for the Team Durango DEX210

Check it out!

MHOR RC Raceway Pizza Fest Footage 4x4 SC

Justin Salerno qualified 3rd and David Konechne qualified 4th for the A-main at MHOR's annual Pizza Fest held this past Saturday. Justin had some rough luck in the opening laps causing a DNF, had it not been for that he surely would have been fighting for the top spot. with a bit of luck Tresrey USA owner David Konechne started 4th and moved up to 2nd. Unfortuantley on the last lap a lapper slowed taking him out and thus a 3rd place finish.

Tresrey Carbon Steering brace for the DEX210 in stock 12/2

Tresrey Japan has shipped out our steering braces and they should be in our hands on Friday 12/2 ready to ship. If you haven't placed yours on back order you'll want to hurry! We have 40 pieces arriving on our first order. Pricing is set at $15.95 so a very affordable upgrade for your DEX210.

Tresrey MOS Coated Big Bores

TYTD063 
Coat Big Bore Shock MOS conversion (DEX210/410 / Front)


TYTD064 
Coat Big Bore Shock MOS conversion (DEX210/410 / rear)


The special coating on high precision machined shock cases (MOS coat) will extremely reduced friction while improving surface hardness significantly. The combination of higher precision machined piston 6 hole pistons are a great upgrade to the ultimate Big Bore shocks (for Team Durango DEX410V3/DEX210) 


※ This product is a conversion set.

Shock Cap Kit Standard, ball joints, sealing cap, and shock nuts are not included. 

Will be released in early December! 

Tresrey Carbon Steering brace for the DEX210

Just released! These will be available in the US at the end of the month. Check out Tresrey-USA.com as they will be on the website and ready to purchase soon!

Tresrey Carbon Chassis for the Team Durango DEX210

Tresrey is making a carbon chassis for the Team Durango DEX210. This has been a popular modification on the DEX410 platform providing more flex and helping to calm the car down on both rough and smooth conditions. Look for these to be stateside sometime in December!

Tresrey Japan A-main 4wd footage

Some footage of Tresrey Japan at Nationals with Kenji the only Durango to make the A-main!

Tresrey 5mm Front Arm Mod

Our friends at Tresrey Japan experimented with this at Japan Nationals and it worked out well. They were the only durango in the A-main and finished 5th. This seems to take some of the steering and "twichiness" out of the car while making it more stable as well. Our US drivers will be using this mode and providing feedback on how it works on the US style tracks.

How to do the mod: Measure 5mm back from the front of the arms. Mark and dremel out the material, then file smooth as not to bind. Place 5mm worth of shims at the rear to move the arm forward 5mm. BAM! You now have your Tresrey 5mm mod done! Tresrey Japan also used the bent ball cup off a 210 to get some steering back if needed, however its not necessary.

Ogio 9800 Sled Bag now in Limited Raw Red Edition!

Use the bag that the world champs use! The OGIO 9800 Sled can get your RC gear there in style, and also in one peice. Don't throw your expensive RC's in a gym bag! Get some top-quality transport using OGIO!

• SLED (Structural Load Equalizing Deck) System for increased durability and handling in the harshest of conditions
• Wide mouth LID opening for easy access to all gear compartments
• Large main compartment with adjustable dividers and padded helmet chamber
• Several multi-use LID compartments for apparel and smaller gear
• iFOM (integrated foam) construction throughout for added gear protection.
• Heavy duty oversized wheels with extra clearance
• Secure hold compression strap system
• Telescoping pull handle
• Dimensions: 34" H x 16.5" W x 15.25" D
• Weight: 14.2 Lbs.
• Capacity: 7500 Cubic Inches
• 
  

Video of Justin Salerno's DEX210 17.5

Justin starts second and moves up to first. Justin is having a good run with his DEX210 before heading off to Spektrum in a couple weeks.

Tresrey Japan at Nationals

Tresrey Japan took on the likes of Kyosho, Yokomo, Tamiya and others at the Japan Nationals held this past weekend at the famous Yatabe Arena. This year was going to be tough as Matsukura was looking to defend his titles.

With not a lot of time to prepare Tresrey Japan headed out with their new 410V3's and DEX210's to see what they could do with the new Duarngo platforms.After some practice and changing setups it was on like Donkey Kong! With some good runs in the qualifiers Kenji Tsuruta was able to qualify for the A-main! With a good clean run he worked his way up to 5th. GREAT results for Tresrey Japan!

1. Naoto Matsukura – Yokomo
2. Shinnosuke Adachi – Kyosho
3. Keisuke Enomoto – Yokomo
4. Tatsuya Sanpei – Kyosho
5. Kenji Tsuruta – Tresrey/Team Durango
6. Kohta Akimoto – Kyosho
7. Juriya Kajiwara – Kyosho
8. Satoshi Maezumi – Tamiya
9. Kazuki Sasatsu – Tamiya
10.Hiroshi Suzuki – Yokomo

Tresrey USA offering full built Team Durango Kits

Tresrey USA is now offering full built kits on all of our Team Durango line of vehicles. If you purchase any other parts off our website those will be installed as well. This allows you to custom build your Durango to suit your needs!

There are a number of reasons to go with a pre-built kit. First is of course time, you are going to save yourself hours of time, just install what you need and your good to go! On average a Team Durango kit takes 6+ hours to build, time not all people have these days. Second Team Durango kits are not for beginners, let us professionally build your kit for you knowing it was done right the first time. We can build you a complete car with all the options from our website, just pick your options and its custom built just for you! The best part is your built Durango kit ships within 48 hours from when your order is placed putting your new Durango at your doorstep in no time ready to hit the track.

Get started and get your kit HERE!

New Tersrey Products! MOS Big Bores and 210 carbon steeing plate

Tresrey Japan has just announced that the ever popular MOS coated shocks are not coming in the Big Bores as well! Get some of the smoothest shocks you can get for your DEX410, DESC410, and DEX210. The low friction coating will give you the response you are looking for and definitely get you dialed in on any track.

In a short time all 210 owners know the steering plate could be beefier! Tresrey has taken care of that for you with the carbon steering plate! High quality, low weight make this a must do upgrade!

Look for more information to be posted on the website! These should be available  in December.